Blowout plug is comprised of a rubber plug on the rear which functions as a relief valve by unseating and venting the gage interior when over pressure reaches approximately 25 PSIg (1.7 bar). To provide a free path for pressure relief, there are four spacer pads which maintain 0.023" clearance when gage is surface mounted. Do not obstruct the gap created by these pads. The blowout plug is not used on models above 180" of water pressure, medium or high pressure models, or on gages which require an elastomer other than silicone for the diaphragm. The blowout plug should not be used as a system overpressure control. High supply pressures may still cause the gage to fail due to over pressurization, resulting in property damage or serious injury. Good engineering practices should be utilized to prevent your system from exceeding the ratings or any component.
O-ring seal for cover assures pressure integrity of case. Samarium Cobalt magnet mounted at one end of range spring rotates helix without mechanical linkages.
Range 0-100 Pa
Minor divisions 2.0
Calibrated for vertical scale position
KAMI MELAYANI PEMESANAN KESELURUH KOTA-KOTA DI INDONESIA Surabaya, Bali, Sidoarjo, Malang, Semarang, Yogyakarta, Pekalongan, Cirebon, Tangerang, Jakarta, Bandung, Sumatra, Aceh, Lampung, Medan, Riau, Batam, Jambi, Padang, Kalimantan, Samarinda, Pekanbaru, Bengkulu, Makasar, Sulawesi, Irian jaya,Papua, Bangka Belitung, Banten, Jabar, Jateng, Jatim, Ntt, Ntb, Gorontalo, maluku DLL
Selain Magnehelic 2000-100P Pressure Gage , Kami juga menyediakan produk lainya juga :
